2010-2018 Ram 6.7L Cummins Monitor Mounts

Monitor mounts on the 2010-2018 Ram 6.7L Cummins

A monitor is only useful if you can see it without taking your eyes far from the road. Monitors in general mount several ways: in a 52 mm (2-1/16 in) gauge pod, in an A-pillar pod, on the steering column, on the dash, with a windshield suction cup or on a flat surface. Each one trades visibility against how permanent the install is.

For the 2010-2018 Ram with the 6.7L Cummins, this collection carries the A-pillar route. A pillar mount puts the screen up near the windshield, close to where your eyes already go when you check a mirror, and it leaves the dash and the factory screen as they are.

Choosing a mount

A pillar mount makes the most sense if you watch numbers while you drive: EGT and transmission temperature on a long tow, regen status around town. It puts the display in a fixed, out-of-the-way spot that does not crowd the dash. If you only glance at your monitor now and then, placement matters less. If you watch it on every grade, put it where your eyes already are.

What we carry

The A-Pillar Display Mount (38602) from Edge Products, listed for the 2010-2018 6.7L Cummins Ram. It is a mount, not a monitor. Check the product page to confirm it holds the Edge display you run. If you still need a display, the Edge Insight CTS3 is in the monitors collection for this truck, and the EAS EGT kit and pressure sensor are in the accessories collection.

Fitment notes

The 38602 is listed for 2010-2018 6.7L Cummins Rams, which spans both the 2010-2012 trucks and the 2013 mid-cycle overhaul. That generation came as a Regular Cab, Crew Cab or Mega Cab, so put your exact cab into the fitment checker on the product page. The 3500, 4500 and 5500 chassis cabs share the engine but are built differently, so verify chassis-cab fitment separately. The 2019 fifth-generation Ram is a different truck, and parts from it generally do not interchange.

Frequently asked questions

Does the A-pillar mount come with a monitor?

No. The 38602 is the mount only. The Edge Insight CTS3 display is sold separately in the monitors collection for this truck, so check that the two match before you order.

Will this mount fit my Mega Cab?

The mount is listed for the 2010-2018 6.7L Cummins Ram, and the Mega Cab is part of that generation. Run your exact truck through the fitment checker on the product page, or call us with your VIN and we will confirm it.

Why mount the monitor on the A-pillar?

It keeps the display near eye level, close to the mirror, so you can check EGT or transmission temperature on a grade without looking down at the dash. It also leaves the dash and the factory screen alone.

Not sure what fits? Call the shop at the number in the header, or use the fitment checker on any product page. We install everything we sell.