Filters
2 products
Not sure it fits your truck?
Our Wildwood, FL techs will confirm the right part for your build before you buy.
Call or Text (352) 722-5295Monitor mounts on the 2020-2022 Ford 6.7L Powerstroke
The 2020 model year was a mid-cycle refresh of the fourth-generation Super Duty. Ford widened the two-bar grille with integrated headlamps and paired the third-generation 6.7L Powerstroke with the 10R140 10-speed, but 2017 through 2022 is one body generation. That is why interior mounts listed for 2017-2022 fit these trucks. The 2023 redesign brought a new interior, so those mounts do not carry forward. This section covers a pillar mount that holds a digital monitor up beside your view of the road, and a vent mount that puts a round gauge where a dash air vent sits.
Choosing a mount
Start with what you are mounting. A digital monitor like the Edge Insight CTS3 shows several readings on one screen, and a pillar mount puts it high and off to the side of your line of sight. A single 52mm gauge adds one dedicated reading, and a vent mount gives it a home in the dash. You can also run both: the monitor for trans temp from the 10R140's TCM and DPF regen status, and a round gauge for one number you always want in view. None of these mounts change how the truck runs. They hold the hardware, and the engine keeps its factory calibration.
What we carry
The Edge Products 18601 A-Pillar Display Mount is made for 2017-2022 6.7L Powerstroke trucks and holds an Edge display on the A-pillar. The SPE Motorsport S200122 Vent Gauge Mount holds a 52mm gauge in a dash vent and is also listed for 2017-2022 6.7L Powerstroke trucks. Each is built for this generation of Super Duty interior rather than as a one-size-fits-all bracket.
Fitment notes
The mounts here are listed for 2017-2022, so they fit the 2020-2022 Super Duty pickup with the 6.7L Powerstroke, and they do not fit the 2023 and newer truck. Match the mount to what goes in it: check the Edge pillar mount's product page for the Edge displays it holds, and measure your gauge, since the SPE vent mount is sized for 52mm. Verify by VIN or call us before you order, and we can install it at the shop in Wildwood, FL.
Frequently asked questions
Do mounts made for the 2017-2019 Super Duty fit my 2021?
Mounts listed for 2017-2022 do. The 2020-2022 trucks are the same fourth-generation Super Duty as 2017-2019 and share the interior, so 2017-2022 mounts apply to both. The mounts in this section carry that 2017-2022 listing.
Can I use these mounts in a 2023 Super Duty?
No. The 2023 truck is the fifth-generation Super Duty with a new interior, and 2017-2022 mounts do not carry over. Look for parts listed specifically for 2023 and newer.
What size gauge fits the SPE vent mount?
The SPE Motorsport S200122 is a 52mm vent gauge mount, which is the common 2-1/16 inch gauge size. Measure your gauge before ordering, and call us if you are not sure it matches.
Not sure what fits? Call the shop at the number in the header, or use the fitment checker on any product page. We install everything we sell.